Can you say "NO"

So Provo Craft came out with this new Machine that I guess was all

the rave at CHA

Well MTC can and has been able to do this

you get your image on the mat haw you want it in the colors you want then print to your printer.

thin make a shadow layer  (if you want a bit of a border)

and then with cheap paper cut this shadow.

Tape the top of this to the mat so it does not move around then

lift off the design

put your printed paper under and line up the edges then press firmly in place remove the top scrap paper

hit cut and this is what you will get

Pin It